Chartplotters / GPS
Multifunction Displays
Sonar Systems
Sonar / GPS Combos
Radar Systems
VHF & SSB Radios
AutoPilots
Panel Instruments
Marine Audio / Video
Handheld GPS Units
Transducers
Antennas & Radomes
Trolling Motors
Turning Point Propellers
Marine Safety
Magnetic Compasses
Riggers & Rod Holders
Chargers & Inverters
Charts & Software
Trim Tabs
Anchors
Metal Detectors
Plumbing
Accessories
|
Home > Riggers & Rod Holders > Lee's Tackle Rod Holders > Lee's Tackle RH5165 Medium Standard Angle 30° Stainless Steel Swivel Base Rod Holder
Lee's Tackle RH5165 Medium Standard Angle 30° Stainless Steel Swivel Base Rod Holder | |  | | | |
RH5165
Standard Angle 30° Short Tube
Medium size Short Swivel Base for Stand-Up Rods with Curved Butts. Has 2" OD x 6-1/2" long tube.
Without a doubt, our swivel base rod holder is the Ultimate Rod Holder for the serious sportsman. Primarily designed to be used with bent butt tackle, the rod holders unique swivel base allows the rod butt to rotate in the rod holder when side pressure is applied to the tip of the rod. This is an indispensable tool, especially important in Giant Blue Fin Tuna fishing, where reel drags in the neighborhood of 60 pounds are frequently used and can result in tremendous forces being applied to the rod holder pin.
Not only does this make sheared rod holder pins a thing of the past but, more importantly, it allows the tip of the rod to follow the fish. This reduces the possibility of line fraying and enhanced drag as the line streams sideways out of the roller tip instead of over the roller. The rod is also more easily removed from the holder since it is not locked on a rigid pin. The swivel base holder functions as a standard rod holder when used with straight butt rods. Straight butt rods can be manually rotated so that the line remains on the tips roller. The amount of torque required to rotate the swivel is set by adjusting the pressure on two nylon drag washers with a ½ inch stainless steel lock nut at the bottom of the rod holder.
|
|
|
